Hi Anders,
Did you receive the sample file? Is the Volume-Quota-Threshold AVP recognized in your case? Regards, Frederiek _____ From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Anders Broman (AL/EAB) Sent: vrijdag 23 februari 2007 16:42 To: Community support list for Wireshark Subject: SV: [Wireshark-users] Diameter unknown AVPs Hi, That should suffice, can you send me a small sample file? Best regards Anders _____ Från: [EMAIL PROTECTED] genom Frederiek Debruyne Skickat: fr 2007-02-23 16:27 Till: Community support list for Wireshark Ämne: Re: [Wireshark-users] Diameter unknown AVPs Hi, The "Attempt to load/use Diameter XML Dictionary" checkbox, in the preferences for Diameter, is checked. The Diameter XML dictionary is set to "C:\Program Files\Wireshark\diameter/dictionary.xml". The Volume-Quota-Threshold AVP (code 869) is not recognized. This AVP is not defined by IETF RFC 3588, but by a 3GPP specification. I am not that familiar with XML, though I noticed the occurrence of following lines in file chargecontrol.xml: <avp name="Volume-Quota-Threshold" code="869" mandatory="must" may-encrypt="no" protected="may" vendor-bit="must" vendor-id="TGPP"> <type type-name="Unsigned32"/> </avp> I'm not sure whether this should be sufficient. It does not seem to be, since the AVP is still not recognized. Regards, Frederiek _____ From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Anders Broman (AL/EAB) Sent: vrijdag 23 februari 2007 16:04 To: Community support list for Wireshark Subject: SV: [Wireshark-users] Diameter unknown AVPs Hi, AVP:s can be dissected either by the data in the file packet-diameter-defs.h or by the Diameter XML files if those preferences are set. See the wiki page for details. The XML library is more updated than the file. What AVP:s are not recognised? Best regards Anders _____ Från: [EMAIL PROTECTED] genom Frederiek Debruyne Skickat: fr 2007-02-23 15:33 Till: wireshark-users@wireshark.org Ämne: [Wireshark-users] Diameter unknown AVPs Hi, I frequently use Wireshark to analyze Diameter protocol traffic. I notice that not all AVPs are recognized. That is, the packet details frame contains a line with "Unknown AVP" in that case. What must be done to make Wireshark recognize these AVPs? I am using the latest Wireshark version, i.e. version 0.99.5. Regards, Frederiek This email has been processed by SmoothZap - www.smoothwall.net _______________________________________________ Wireshark-users mailing list Wireshark-users@wireshark.org http://www.wireshark.org/mailman/listinfo/wireshark-users This email has been processed by SmoothZap - www.smoothwall.net <http://www.smoothwall.net/> This email has been processed by SmoothZap - www.smoothwall.net
_______________________________________________ Wireshark-users mailing list Wireshark-users@wireshark.org http://www.wireshark.org/mailman/listinfo/wireshark-users