Joe After your update to my original post on the mailing list, I had run through a set of tests with a freshly started instance of WSJT-X, but also could not reproduce the problem, each invocation of 'Tx Next' triggered a transmit cycle on the upcoming 2-min period.
However, I have run into the issue several times since then, including this evening when queuing up on 630M. I'll have to perform more tests to try and isolate what conditions may be causing this problem, but it definitely exists. When I clicked 'Tx Enable' followed by 'Tx Next' this evening, around odd-min:30s, the upcoming 2-min period was an RX cycle and the following a TX cycle. 73 Eric NO3M On 07/23/2015 11:38 AM, Joe Taylor wrote: > Hi Eric, > > There is no intentional cutoff time for requesting "Tx Next". > > I have not been able to confirm that activating "Tx Next" close to the > end of a 2-minute period fails to trigger a TX period on the next > 2-minute cycle. I tried t=55s, t=57s, and t=59s in the "odd" minute of > reception, and in all cases a transmission started at t=00s. > > For these tests I set TxPct=1%, set "Monitor" and "Enable TX" active. I > then clicked "Tx Next" at the stated times, right up to t=59s. > > (I did not check to see what happens if decoding is still underway past > t=00s. Should be OK, but? ...) > > -- 73, Joe, K1JT > > On 7/14/2015 10:57 PM, Eric NO3M wrote: >> Re: WSPR mode >> >> "Tx Next" does not seem to trigger a TX period on the upcoming 2-min >> cycle when clicked "close" to the 2-min crossover. I cannot answer >> exactly when the cutoff point (ie. time to next 2-min crossover) seems >> to happen, as this has only been a casual observation while preparing >> for a transmit session and wanting to get a quick first TX period off. >> Is there an intentional cutoff or is this a bug? >> >> 73 Eric NO3M / WG2XJM >> >> >> ------------------------------------------------------------------------------ >> Don't Limit Your Business. Reach for the Cloud. >> GigeNET's Cloud Solutions provide you with the tools and support that >> you need to offload your IT needs and focus on growing your business. >> Configured For All Businesses. Start Your Cloud Today. >> https://www.gigenetcloud.com/ >> _______________________________________________ >> wsjt-devel mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/wsjt-devel > ------------------------------------------------------------------------------ > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel ------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
