Hi all, Please allow me you ask some questions about the MSK144 operation and the related settings, especially in relation to the FT-2000. But the operation is probably similar with other Xcvr's.
In the main WSJT-X window, there is a settings "RX 1500 Hz", which is probably the default. What is the TX frequency ? Is it the same as the RX frequency or is it always 1500 Hz ? I do not understand exactly which are the right settings to use. Please allow me to consider the 6 m band as an example. If I understand right, the calling frequency is 50.280 kHz. How to change to the operation frequency after I have got a response from the other station ? How do I known about this operation frequency ? I have seen that when WSJTX switches from TX to RX mode, the TX offset setting of the XCVR is reset to zero. If I select the split mode, in the WSJTX config, the frequency of the second VFO is reset to the frequency of the main VFO when WSJTX switches from TX to RX mode. How can I add the calling frequency to the working frequency list of the settings ? I have not found these information in the operating manual. Will this information be added later ? Many thanks for your help. Best wishes, Claude ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
