Hi Wolfgang,
On 7/11/2017 12:22 PM, Wolfgang OE1MWW wrote:
If I have "TX even/1st" unchecked and I "Enable TX",
the transmission starts with CQ, disregarding the 15 sec. cycle time.
I checked that again, this can happen twice a minute, depends on the
setting and the activation of "Enable TX".
Nevertheless, I think in terms of a 'clean protocol', this should not
be possible, to start transmission during the cycle. It will send out
an un-complete message, because at the end of the cyle the TX goes off
again.
73 de Wolfgang
OE1MWW
I think you are objecting to the ability to start a transmission after
the nominl start time, thus ensuring that only some fraction of the
normal number of symbols will be sent.
If I have understood you correctly, I do not understand why you would
object to this behavior. All WSJT-X modes except ISCAT include
sufficient forward error correction that even if (say) 1/3 of a
transmission is missing, decoding may still succeed.
-- 73, Joe, K1JT
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel