Try Full Call in TX3 -- then your full call only shows up in TX3, 5 and 6
de Mike W9MDB
On Tuesday, May 8, 2018, 2:01:38 PM CDT, Jim Emerson <jime...@hotmail.com>
wrote:
I am using v1.9.0-rc4. My callsign is ka2aic/ve3. When standard messages are
generated I get as an example:
Tx1. De ka2aic/ve3 fn14
Tx2. Ux5io ka2aic-19
Tx3. De ka2aic/ve3 r-19
Tx4. Ux5io ka2aic rrr
Tx5 De ka2aic/ve3 73
Tx6. Cq ka2ic/ve3 fn14
It would be very helpful if I could set a custom order of sending sequence.
Such as assigning tx2 to go before tx1. Or always using the ka2aic/ve3 call.
Please advise.
Thank you
Jim
Emerson------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org!
http://sdm.link/slashdot_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
