Richard,
If you have an external switch you need the interface for Yaesu to run it.
If you have two outputs on the back of the radio, there should be a menu option
set up to select the antenna
based on the band. Yaesu likes lots of menus.
73,
Pat W5THT
----- Original Message -----
From: "Richard PD1BHZ" <pd1...@ziggo.nl>
To: wsjt-devel@lists.sourceforge.net
Sent: Monday, July 30, 2018 8:15:32 AM
Subject: [wsjt-devel] wsjt-x 1.9.1 yaesu ftdx 3000 antenna not switch if
choosen a other band
Hi all,
I just buy a new radio Yaesu ftdx 3000 but see a little problem.. don’t now if
it’s my fault If I switch the band in wsjtx 1.9.1 software from say 20mtr to
40mtr my antenna is not switch from ant1 to ant2.
If I push the band button on the radio the ant switch from ant1 to ant2.
With my other radio Kenwood ts590s the antenna switch from ant1 to ant2
automatic if I changed band in the wsjtx software.
Off course I hope someone have a answer for me
Best regards PD1BHZ Richard
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
