Hi Bill, Thanks for your input. I have been through that before so am aware of the possibility. However I ruled it out because this never happens on v1.91 or any of the RC's or any other software for that matter . It still happens even if I have not transmitted. I am sure that it must be something other than RFI. All of the various sleep timers to conserve power were disabled many months ago, even though they were apparently never a source of difficulty. Guess I will have to stay on v1.91 or switch to MSHV or JTDX until the source of the problem can be identified.
Best regards, Gary, K7EK Sent from BlueMail On Dec 11, 2018, 09:58, at 09:58, Bill Somerville <[email protected]> wrote: >On 11/12/2018 09:06, Gary - K7EK via wsjt-devel wrote: >> I have a similar problem. After WSJTX 2.0 runs for approximately >> 10-15 minutes in FT8 mode, the waterfall window freezes and all >> decoding stops. Interestingly all of the buttons and dropdown menus >in >> WSJTX still work. I can click on tune and it transmits fine. If I >> restart WSJTX and close the waterfall window it decodes without >> further issue. I never experienced this with any of the RC's or 1.91. > >> I am running Windows 7 Home Premium (64 bits) on a quad core >> processor and 4 gb of memory. Has anyone else experienced this? >Thanks. >> >> Best regards, >> >> Gary, K7EK > >Hi Gary, > >this is a symptom of the audio input stopping or being disconnected, >i.e. there are no audio samples being delivered to WSJT-X. Common >causes >are USB audio devices getting reset by RFI or being put to sleep by the > >operating system to conserve power (the default behaviour on Windows). > >73 >Bill >G4WJS. > > > >_______________________________________________ >wsjt-devel mailing list >[email protected] >https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
