Try this
rigctl -p com20 -P RTS -vvvvvv T 1 t T 0
Replace com20 with your serial port device. PTT should toggle on/off.
I suspect it will lock up when doing set_ptt which would mean your FTDI chip is
not functioning properly.
Mike W9MDB
On Monday, June 14, 2021, 04:04:04 PM CDT, Daniel Uppström
<[email protected]> wrote:
Hi Bill,
No CAT control. I am using my own home built transceiver, PTT:ed by DTS
on a FTDI chip.
The RX thermometer stops moving and waterfall stops scrolling.
And now, when I went back to version 2.2.2, I still have the same
problem. It was not like that before, I am sure.
73 Daniel
On 6/14/21 9:09 PM, Bill Somerville wrote:
> On 14/06/2021 19:52, Daniel Uppström wrote:
>> Just updated from WSJTX 2.2.2 to 2.4.0 on a Raspberry Pi 3.
>> When transmitting in FT8 it does not seem to go back into
>> reception/decoding. Thus I consider it unusable.. Any thoughts?
>
> Hi Daniel,
>
> are you using CAT control? What rig are you using? What PTT Method do
> you use? Does the Rx thermometer style level indicator stop moving?
> Does the waterfall display stop scrolling?
>
> 73
> Bill
> G4WJS.
>
>
>
> _______________________________________________
> wsjt-devel mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
