Guesswork, but it looks like the two streams are conflicting somehow?
Maybe if the USB hubs are external and not independently powered try using
direct connections?
Otherwise you could try running the 890 using RS232 and separate audio
connections?
No idea on debugging software, search engine should help.
Sorry can't be of more use.
Alan G0TLK, sent from my mobile device
On 17 July 2021 13:34:46 Conrad PA5Y via wsjt-devel
<[email protected]> wrote:
This is a showstopper; the USB hubs are set so that power saving is not
active. Does anybody have any ideas?
Regards
Conrad PA5Y
From: Conrad PA5Y via wsjt-devel <[email protected]>
Sent: 17 July 2021 07:52
To: [email protected]
Cc: Conrad PA5Y <[email protected]>
Subject: [wsjt-devel] wsjt-x v2.5.0-rc3
Good morning.
I have 2 instances of wsjt-x v2.5.0-rc3 running, one connected to a K3S and
the other to a recently acquired TS-890S. The K3S audio input runs without
problems for days, however the TS-890S does not. It fails after a short
while. Usually stopping and restarting monitor restores the stream. Running
the TS-890S on its own without the 2nd K3S instance makes no difference to
the behaviour. Interestingly the 2 radios use the same audio drivers and
com port drivers. If I use another type of software with the TS-890S the
problem does not occur even after 30 hrs, which suggests that there is no
hardware problem.
Are there some diagnostics I can run or file that I can provide to help
with debugging? I will start on 6m EME very soon and I will need Q65.
Any help would be appreciated.
Regards
Conrad PA5Y
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
