Andy, I have start frequency of Wide Graph at 100Hz, even tried with start at 0Hz Rx freq. never goes below 200. Same for Tx freq.
Same thing if I enter numeric values in corresponding boxes. Should mention that I am running FT8/4. 73 Notko/SA5NTK From: Andrew Neumeier via wsjt-devel [mailto:wsjt-devel@lists.sourceforge.net] Sent: den 22 juni 2022 21:56 To: Notko Mermerski via wsjt-devel <wsjt-devel@lists.sourceforge.net> Cc: Andrew Neumeier <ka2...@yahoo.com> Subject: Re: [wsjt-devel] Change request Notko, Can you not just change the start frequency in the Wide Graph? Mine is set at 100hz. 73, Andy, ka2uqw On Wednesday, June 22, 2022 at 03:44:53 PM EDT, Notko Mermerski via wsjt-devel <wsjt-devel@lists.sourceforge.net <mailto:wsjt-devel@lists.sourceforge.net> > wrote: Hi everybody, I am running WSJT-X 2.5.4. Noticed that it is impossible to set Rx (green bracket) nor Tx frequency (red bracket) below 200Hz. I can understand that there is a rationale for this limit, but modern TRXes are capable of receiving below 200Hz. I am seeing decoded messages below 200Hz and I would like to be able to monitor them in the Rx pane of WSTJ-X main window. I am aware that there is a workaround to achieve this, but still, it is a workaround. Would it be possible to lower this limit to at least 100 Hz? 73 Notko/SA5NTK _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net <mailto:wsjt-devel@lists.sourceforge.net> https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel