This does not control one of the two radios...for instance the frequency
change.
I use the virtual audio channel to control the RTL-SDR...with Gqrx and
it works fine.
As well I control the IC-706 via serial interface...
...but I need to control both at the same time.
So I suppose that it can be done only modifying WSJTX
73
Pino ZP4KFX
On 8/23/22 18:07, Don Hawbaker wrote:
I think all you need to do is configure the WSJT audio to use the audio channel
that goes to you transmitter for transit, and connect the WSJT audio receive
channel to the SDR audio. You may have to use a virtual audio channel. It’s
difficult to suggest a detailed set up without knowing the specific equipment
you want to use.
Look at you WSJT setup tab and see what sources you have listed.
Sent from my iPad
On Aug 21, 2022, at 2:20 PM, Pino Zollo via wsjt-devel
<wsjt-devel@lists.sourceforge.net> wrote:
Please how could I configure wsjtx to receive via an SDR dongle and transmit
via a regular radio....(IC-706 in
my case) ?
If not possible, please, consider it as a future improvement.
This is very useful on the low bands... e.g. on 630m the IC-706 transmits
something...but its RX is
undefined.
On the contrary my RTL-SDR with proper filters should be better.
73
Pino ZP4KFX
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
