Hi Gary,
On 4/26/2023 7:59 AM, K9RX wrote:
I had sent this on the 16^th of April but did not get a response… I
believe these are germane questions – and as far as I’ve been able to
tell they are not addressed in the manual. These pertain to the use of
“average” when running Q65. I’ve asked these questions in the EME group
– no one knew the answers but were also interested.
1. /Does average apply to each of multiple signals in the window?/
Yes
2. /Is there a separate average queue for 1^st and 2^nd sequence?
(would be great if RXing both looking for stns)/
Yes
3. /IF each signal has its own average: and if Auto Clear is on does it
only clear the averages for those that have now decoded or /
4. /if only one station decodes and there are say 3 stations there (in
the averages) do all the averages now get cleared out?/
"Auto Clear Avg after decode" clears the averaging accumulator for the
relevant Odd or Even sequence when decoding at the selected offset
frequency is successful. The accumulator for the other sequence remains
intact.
The small window near center of the status bar (see attached screen
shot) shows the number of Rx intervals available in the accumulator for
each sequence.
I assumed 4. Which is why I turned off auto clear since if it is 4 above
it would never do an average if Lance, in the even cycle, always
decoded. And as mentioned I went from 0 averages in the AVG DEC window
with it on to several ongoing with it off.
-- 73, Joe, K1JT_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
