Am 25.06.2018 um 20:17 schrieb al...@libero.it: > I'm sorry, i admit I wasn't clear enough. > so, basically we have 30 little windows pc that act as thinclient. At the > welcome screen there are the options to use "windows" or "linux" and each > with a specific configration set, call it "session". So when I press "Linux" > it calls the MYSESSION only with its settings. > Now, I wanted to keep this welcome interface as clean and easy possible. The > good was pyHoca-gui with its "username/password" window, but again, it's too > slow to start once a user press "Linux" > > then I saw that x2goclient can accept many parameters if run by command line > and infact it works nice with the ones I specified in the previous message. > Only the GUI is not "clean": it's split vertically in two parts and "worst", > on the right, one can still see the name of the session. Well, it's not a > drama, but it's not so clean as the pyHoca interface.
You could also use --close-disconnect, that way X2GoClient terminates after disconnecting, rather than placing you in the session tiles view. Kind Regards, Stefan Baur -- BAUR-ITCS UG (haftungsbeschränkt) Geschäftsführer: Stefan Baur Eichenäckerweg 10, 89081 Ulm | Registergericht Ulm, HRB 724364 Fon/Fax 0731 40 34 66-36/-35 | USt-IdNr.: DE268653243 _______________________________________________ x2go-user mailing list x2go-user@lists.x2go.org https://lists.x2go.org/listinfo/x2go-user