On Tue, Oct 05, 2010 at 06:42:52PM -0700, we recorded a bogon-computron 
collision of the <[email protected]> flavor, containing:
> I am fairly sure that my TNC is working correctly (since on almost every rx I 
> see a little red arrow flash on the bottom of the screen, far left of the 
> information boxes) however I do can't seem to get any data up on the map. I 
> have 
> tried to change the bps to make sure that that was not the problem, but still 
> no 
> luck. I am using an OpenTracker+ with the KISS firmware, and the Serial KISS 
> tnc 
> interface. 

Make sure that the baud rate of your Xastir interface matches the baud rate
of the OT+ --- I believe it uses 9600 baud, and I think Xastir defaults to
something else.  Someone else here had a similar problem recently.

-- 
Tom Russo    KM5VY   SAR502   DM64ux          http://www.swcp.com/~russo/
Tijeras, NM  QRPL#1592 K2#398  SOC#236        http://kevan.org/brain.cgi?DDTNM
 "The truth will set you free, but first it will piss you off."

_______________________________________________
Xastir mailing list
[email protected]
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir

Reply via email to