> site table "dhcpinterfaces"
>
> dhcpinterfaces: The network interfaces DHCP should listen on. If it is
> the same
> for all nodes, use simple comma-separated list of NICs.
> To
> specify different NICs for different nodes:
> mn|eth1,eth2;service|bond0.
>
>
Thanks Jim,
The person who did the xcat configuration didn't set dhcpinterfaces in the site
table at all. I am bit confused about your last section about assigning
different nic for different nodes. What would it look like in tabdump?
Francois
This email may be confidential and subject to legal privilege, it may
not reflect the views of the University of Canterbury, and it is not
guaranteed to be virus free. If you are not an intended recipient,
please notify the sender immediately and erase all copies of the message
and any attachments.
Please refer to http://www.canterbury.ac.nz/emaildisclaimer for more
information.
------------------------------------------------------------------------------
RSA(R) Conference 2012
Save $700 by Nov 18
Register now
http://p.sf.net/sfu/rsa-sfdev2dev1
_______________________________________________
xCAT-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/xcat-user
