Hi,
On 07/20/2017 04:31 AM, Damir Krstic wrote:
Hi all,
We just got couple of new x3650 servers in and discovering them went
without a problem. Running bmcsetup worked ok too. For some reason after
the bmc setup was done, the interface was still in dedicated mode and
per Jarrod's instructions some time ago, I was able to change it to
shared. What Jarrod asked me, back in 2015 to do was to ssh to the node
while bmcsetup was running and execute following command:
ipmitool raw 0xc 1 1 0xc0 0
you can try to "reset" the BMC:
ipmitool mc reset warm (or "cold" if a warm reset is not enough).
Or maybe the raw command changed since there are new servers (and new
BMCs firmware I guess)?
On a Supermicro I had to run this from the OS to set the BMC to shared:
ipmitool raw 0x30 0x70 0x0c 1 1
And to check the actual value:
ipmitool raw 0x30 0x70 0x0c 0
Nicolas
This sets the interface to the shared mode. I did that and it looks OK.
However, telnet <node>-bmc I get connection refused and I don't recall
ever getting this message before.
Any help is appreciated.
Thanks,
Damir
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
xCAT-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/xcat-user
