Hello In fact I’ve found out that confignics is not to be used anymore and it’s better to use confignetwork instead. Also I had the confignetwork script before the confignetwork script in the postscript table, so the installer was trying to configure ib0 before the driver was installed. Now with the proper order it’s working better (even though I can’t run the ofed install script manually for some reason) and all interfaces are configured as I wish :)
However there’s still something going on because after configuring the bond the connection with the management node is lost, meaning the installation of a node does not end properly... Best regards, Antoine Huette HPC engineer Bechtle > Le 28 févr. 2020 à 00:23, Christian Caruthers <[email protected]> a écrit > : > > I can't speak to the MOFED postscript, but for setting up nics, I've used > the nics table and confignetwork -s (-s setting the boot interface to static): > > niccustomscripts.bond0=configbond bond0 ib0@ib2 mode=1@miimon=100 > nicdevices.bond0=ib0|ib2 > nichostnamesuffixes.bond0=-ib > nicips.bond0=x.x.x.x > nicnetworks.bond0=ib > nictypes.bond0=bond > nictypes.ib0=Infiniband > nictypes.ib2=Infiniband > > This works in a recent customer site. > > Regards, > Christian Caruthers > Lenovo Professional Services > Mobile: 757-289-9872 > > -----Original Message----- > From: Huette, Antoine <[email protected]> > Sent: Thursday, February 27, 2020 10:50 AM > To: xCAT Users list <[email protected]> > Subject: [External] [xcat-user] Ofed install and nic config > > Hello, > > The provided mlnxofed_ib_install script is not working for Centos 7.7 with > the 4.7 iso files (tested with 4.7-1.0.0.1 and 4.7-3.2.9.0) When launching > the script it stops after putting « nodeststate is« Also it is not clear if > i need both confignetworks and confignics, because i need bonding on the > internal network and ib0 configuration done when provisioning Nics config is > not done properly because after bond0 is configured the node installer cannot > ping the master anymore. > > Thanks for the help > > Best regards > > > Antoine Huette > HPC engineer > Bechtle > _______________________________________________ > xCAT-user mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/xcat-user > > _______________________________________________ > xCAT-user mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/xcat-user _______________________________________________ xCAT-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/xcat-user
