Hello Charlie,
Thanks for Xcircuit, I use it lots. Unfortunately the Mac port does not
work in the 3.7.x releases.
To see this, open a fink installation of xcircuit 3.7.35 on a mac
10.6.8. "Netlist->Make pin" on a new blank sheet. Type some text for
the pin and press enter. Now hover over the pin and type "e" to change
the text.
Crash (Abort trap).
This is not the case on Suse linux 10.0/11.2, cygwin/win32(XP), or
cygwin/win64(Win7).
I don't have a Mac. Is is possible for you to run a debugger on the
code and trace the source code line that causes the crash?
---Tim
+--------------------------------+-------------------------------------+
| Dr. R. Timothy Edwards (Tim) | email: [email protected] |
| Open Circuit Design, Inc. | web: http://opencircuitdesign.com |
| 22815 Timber Creek Lane | phone: (301) 528-5030 |
| Clarksburg, MD 20871-4001 | cell: (240) 401-0616 |
+--------------------------------+-------------------------------------+
_______________________________________________
Xcircuit-dev mailing list
[email protected]
http://www.opencircuitdesign.com/mailman/listinfo/xcircuit-dev
