Thanks Tim for your response. I followed the suggestion from below link and it is not crashing anymore. now i will start some design and let see if all the features are working perfectly.
Thanks again for your help. -Pandey. On Wed, May 23, 2012 at 9:06 AM, Tim Edwards <[email protected]>wrote: > Hello Pandey, > > > I have built xcircuit.3.7.39 on Mac10.6.8. I have installed latest tcl/tk >> 8.5.11. >> it is crashing at startup, i tried to run through gdb and found below >> message. >> I am sure it would be a known issue and you will be able to help me. >> > > Starting program: /usr/local/lib/xcircuit-3.7/**xcircexec >> Reading symbols for shared libraries >> .++++++++++...................**..............................** >> ..............................**................... >> done >> Reading symbols for shared libraries . done >> Reading symbols for shared libraries . done >> Reading symbols for shared libraries . done >> Reading symbols for shared libraries . done >> Reading symbols for shared libraries . done >> Reading symbols for shared libraries . done >> Reading symbols for shared libraries . done >> Starting xcircuit under Tcl interpreter >> >> Program received signal EXC_BAD_ACCESS, Could not access memory. >> Reason: KERN_PROTECTION_FAILURE at address: 0x00000030 >> 0x002f01e3 in CmapRecForColormap () >> > > This has been reported before; check the discussion on: > > http://blog.gmane.org/gmane.**comp.graphics.xcircuit.devel/** > month=20100701<http://blog.gmane.org/gmane.comp.graphics.xcircuit.devel/month=20100701> > > The issue, as I understand it, is that there is a Mac graphics ("Aqua") > based version of Tcl/Tk that is found and linked to by xcircuit, and > that it is incompatible with the X11 graphics calls made by xcircuit. > To avoid the problem, you will need an X11-based version of Tcl/Tk. > The email thread above says to get and compile the Tcl/Tk Unix sources > (presumably downloaded from www.tcl.tk). > > If you think that you *do* have the X11 version of Tcl/Tk 8.5.11, then > I will have to revisit the problem. Let me know. > > Regards, > Tim > > +-----------------------------**---+--------------------------** > -----------+ > | Dr. R. Timothy Edwards (Tim) | email: [email protected] | > | Open Circuit Design, Inc. | web: http://opencircuitdesign.com | > | 22815 Timber Creek Lane | phone: (301) 528-5030 | > | Clarksburg, MD 20871-4001 | cell: (240) 401-0616 | > +-----------------------------**---+--------------------------** > -----------+ > _______________________________________________ Xcircuit-dev mailing list [email protected] http://www.opencircuitdesign.com/mailman/listinfo/xcircuit-dev
