Hello,
I use this hardware configuration:
ProLiant BL465c G7 with embedded Emulex NC551i dual-port 10 Gb Converged
Network Adapter
Two HP VirtualConnect Flex-10 Enet Module
Cisco C2960G
All firmwares are in current versions. Emulex NC551i using FW version
4.1.450.7 corresponding with be2net Emulex OneConnect 10Gbps NIC Driver
4.1.450.7 in XCP kernel.
I set two NICs to bond0:
eth0 is in the network on the first HP VC Flex-10 with uplink thru port
X3 connected to C2960G
eth1 is in the network on the second HP VC Flex-10 with uplink thru port
X3 connected to C2960G
This is easiest setup for redundant connections over two HP VC Flex-10
verified as correct by HP support without any hardware problems.
After switching off the first HP VC Flex-10, all traffic is
automatically send thru second HP VC Flex-10 - this is OK.
After switching on the first HP VC Flex-10, communication is interrupted
forever - this is BAD.
The problem can be solved only after reboot XCP.
I'm creating bond by using this command:
xe bond-create network-uuid=uuid_bond_network pif-uuids=uuid_eth0,uuid_eth1
States of NIC correspond with output of:
ovs-appctl bond/show bond0
I would appreciate any advice.
Thank you
Jan Martinu
_______________________________________________
Xen-api mailing list
Xen-api@lists.xen.org
http://lists.xen.org/cgi-bin/mailman/listinfo/xen-api
