On Thu, 10 Dec 2020, Julien Grall wrote:
> On 10/12/2020 02:30, Stefano Stabellini wrote:
> > On Mon, 30 Nov 2020, Oleksandr Tyshchenko wrote:
> > > From: Oleksandr Tyshchenko <oleksandr_tyshche...@epam.com>
> > >
> > > We need to send mapcache invalidation request to qemu/demu everytime
> > > the page gets removed from a guest.
> > >
> > > At the moment, the Arm code doesn't explicitely remove the existing
> > > mapping before inserting the new mapping. Instead, this is done
> > > implicitely by __p2m_set_entry().
> > >
> > > So we need to recognize a case when old entry is a RAM page *and*
> > > the new MFN is different in order to set the corresponding flag.
> > > The most suitable place to do this is p2m_free_entry(), there
> > > we can find the correct leaf type. The invalidation request
> > > will be sent in do_trap_hypercall() later on.
> >
> > Why is it sent in do_trap_hypercall() ?
>
> I believe this is following the approach used by x86. There are actually some
> discussion about it (see [1]).
>
> Leaving aside the toolstack case for now, AFAIK, the only way a guest can
> modify its p2m is via an hypercall. Do you have an example otherwise?
OK this is a very important assumption. We should write it down for sure.
I think it is true today on ARM.
> When sending the invalidation request, the vCPU will be blocked until all the
> IOREQ server have acknowledged the invalidation. So the hypercall seems to be
> the best position to do it.
>
> Alternatively, we could use check_for_vcpu_work() to check if the mapcache
> needs to be invalidated. The inconvenience is we would execute a few more
> instructions in each entry/exit path.
Yeah it would be more natural to call it from check_for_vcpu_work(). If
we put it between #ifdef CONFIG_IOREQ_SERVER it wouldn't be bad. But I
am not a fan of increasing the instructions on the exit path either.
>From this point of view, putting it at the end of do_trap_hypercall is a
nice trick actually. Let's just make sure it has a good comment on top.
> > > Signed-off-by: Oleksandr Tyshchenko <oleksandr_tyshche...@epam.com>
> > > CC: Julien Grall <julien.gr...@arm.com>
> > >
> > > ---
> > > Please note, this is a split/cleanup/hardening of Julien's PoC:
> > > "Add support for Guest IO forwarding to a device emulator"
> > >
> > > Changes V1 -> V2:
> > > - new patch, some changes were derived from (+ new explanation):
> > > xen/ioreq: Make x86's invalidate qemu mapcache handling common
> > > - put setting of the flag into __p2m_set_entry()
> > > - clarify the conditions when the flag should be set
> > > - use domain_has_ioreq_server()
> > > - update do_trap_hypercall() by adding local variable
> > >
> > > Changes V2 -> V3:
> > > - update patch description
> > > - move check to p2m_free_entry()
> > > - add a comment
> > > - use "curr" instead of "v" in do_trap_hypercall()
> > > ---
> > > ---
> > > xen/arch/arm/p2m.c | 24 ++++++++++++++++--------
> > > xen/arch/arm/traps.c | 13 ++++++++++---
> > > 2 files changed, 26 insertions(+), 11 deletions(-)
> > >
> > > diff --git a/xen/arch/arm/p2m.c b/xen/arch/arm/p2m.c
> > > index 5b8d494..9674f6f 100644
> > > --- a/xen/arch/arm/p2m.c
> > > +++ b/xen/arch/arm/p2m.c
> > > @@ -1,6 +1,7 @@
> > > #include <xen/cpu.h>
> > > #include <xen/domain_page.h>
> > > #include <xen/iocap.h>
> > > +#include <xen/ioreq.h>
> > > #include <xen/lib.h>
> > > #include <xen/sched.h>
> > > #include <xen/softirq.h>
> > > @@ -749,17 +750,24 @@ static void p2m_free_entry(struct p2m_domain *p2m,
> > > if ( !p2m_is_valid(entry) )
> > > return;
> > > - /* Nothing to do but updating the stats if the entry is a
> > > super-page. */
> > > - if ( p2m_is_superpage(entry, level) )
> > > + if ( p2m_is_superpage(entry, level) || (level == 3) )
> > > {
> > > - p2m->stats.mappings[level]--;
> > > - return;
> > > - }
> > > +#ifdef CONFIG_IOREQ_SERVER
> > > + /*
> > > + * If this gets called (non-recursively) then either the entry
> > > + * was replaced by an entry with a different base (valid case) or
> > > + * the shattering of a superpage was failed (error case).
> > > + * So, at worst, the spurious mapcache invalidation might be
> > > sent.
> > > + */
> > > + if ( domain_has_ioreq_server(p2m->domain) &&
> > > + (p2m->domain == current->domain) &&
> > > p2m_is_ram(entry.p2m.type) )
> > > + p2m->domain->mapcache_invalidate = true;
> >
> > Why the (p2m->domain == current->domain) check? Shouldn't we set
> > mapcache_invalidate to true anyway? What happens if p2m->domain !=
> > current->domain? We wouldn't want the domain to lose the
> > mapcache_invalidate notification.
>
> This is also discussed in [1]. :) The main question is why would a
> toolstack/device model modify the guest memory after boot?
>
> If we assume it does, then the device model would need to pause the domain
> before modifying the RAM.
>
> We also need to make sure that all the IOREQ servers have invalidated
> the mapcache before the domain run again.
>
> This would require quite a bit of work. I am not sure the effort is worth if
> there are no active users today.
OK, that explains why we think p2m->domain == current->domain, but why
do we need to have a check for it right here?
In other words, we don't think it is realistc to get here with
p2m->domain != current->domain, but let's say that we do somehow. What's
the best course of action? Probably, set mapcache_invalidate to true and
possibly print a warning?
Leaving mapcache_invalidate to false doesn't seem to be what we want to
do?
> > > BUILD_BUG_ON(NR_hypercalls < ARRAY_SIZE(arm_hypercall_table) );
> > > @@ -1459,7 +1460,7 @@ static void do_trap_hypercall(struct cpu_user_regs
> > > *regs, register_t *nr,
> > > return;
> > > }
> > > - current->hcall_preempted = false;
> > > + curr->hcall_preempted = false;
> > > perfc_incra(hypercalls, *nr);
> > > call = arm_hypercall_table[*nr].fn;
> > > @@ -1472,7 +1473,7 @@ static void do_trap_hypercall(struct cpu_user_regs
> > > *regs, register_t *nr,
> > > HYPERCALL_RESULT_REG(regs) = call(HYPERCALL_ARGS(regs));
> > > #ifndef NDEBUG
> > > - if ( !current->hcall_preempted )
> > > + if ( !curr->hcall_preempted )
> > > {
> > > /* Deliberately corrupt parameter regs used by this hypercall.
> > > */
> > > switch ( arm_hypercall_table[*nr].nr_args ) {
> > > @@ -1489,8 +1490,14 @@ static void do_trap_hypercall(struct cpu_user_regs
> > > *regs, register_t *nr,
> > > #endif
> > > /* Ensure the hypercall trap instruction is re-executed. */
> > > - if ( current->hcall_preempted )
> > > + if ( curr->hcall_preempted )
> > > regs->pc -= 4; /* re-execute 'hvc #XEN_HYPERCALL_TAG' */
> > > +
> > > +#ifdef CONFIG_IOREQ_SERVER
> > > + if ( unlikely(curr->domain->mapcache_invalidate) &&
> > > + test_and_clear_bool(curr->domain->mapcache_invalidate) )
> > > + ioreq_signal_mapcache_invalidate();
> >
> > Why not just:
> >
> > if ( unlikely(test_and_clear_bool(curr->domain->mapcache_invalidate)) )
> > ioreq_signal_mapcache_invalidate();
> >
>
> This seems to match the x86 code. My guess is they tried to prevent the cost
> of the atomic operation if there is no chance mapcache_invalidate is true.
>
> I am split whether the first check is worth it. The atomic operation should be
> uncontended most of the time, so it should be quick. But it will always be
> slower than just a read because there is always a store involved.
I am not a fun of optimizations with unclear benefits :-)
> On a related topic, Jan pointed out that the invalidation would not work
> properly if you have multiple vCPU modifying the P2M at the same time.
Uhm, yes.
