Hello, I am currently working on the port of Xenomai for the TI OMAP L-138 processor (DaVinci platform). I didn't finish yet. As soon as I finish, I will send the patch, and I intend to do so next week.
I followed the instructions from Xenomai's wiki page. Until now, I am able to boot my ported kernel with the I-Pipe feature. When I build the kernel with Xenomai feature, the kernel stops to boot. I have some questions: 1) How is the better way to debug the boot process? When my kernel stops booting, after the message "Uncompressing .........." the boot halts. I don't know what is going on and I don't know what to do in order to follow the processes internally. Both debuggers (kernel and i-ipipe) are enabled in the kernel configuration. 2) How tested the code must be done in order to send you a patch? Is there any minimal set of tests that I should perform just before sending you a patch for revision? Best regards, Flavio Flavio de Castro Alves Filho Embedded Software Services www.phiinnovations.com +55 11 84 94 56 76 2009/12/15 Sergey Didenko <[email protected]> > hi > > you are right, this is not common patch, but still it is a patch and you > can apply it. > to do that, run the command > patch -p0 < new-patch > in you linux kernel folder > > if you open the *.patch file with text editor, you will see the changes for > only 4 files. > This patch includes the changes to support Marvell SoC MV88F6290 with > Counting Down free running counter. > > Kernel version is 2.6.29-v02.00.29 > Xenomai version is 2.4.9.1 > > Sergey > > 2009/12/16 Aleksandr Lavrushchenko <[email protected]> > >> On Fri, 6 Nov 2009 18:39:05 +0900 >> Sergey Didenko <[email protected]> wrote: >> >> > Hello >> > >> > Here it is! >> > I'm very sorry for this delay, it was related to 2 facts: >> > 1) before publishing I wanted to put the code in order and to verify >> > once again >> > 2) I was extremely busy these days, especially with the project on >> > Xenoimai and I could not do anything with that code except making my >> > project work on it. >> > >> > I want to say only that it is working and you can use it with some >> > changes for your board. >> > One more time sorry for very late reply. >> Hi. >> I want to ask some questions about patch. >> For which kernel version (and kernel patches if any) and xenomai version >> this patch. And how apply it right, since it's not common patch, rather >> suite of files? >> >> Thank you for answer. >> -- >> WBR Lavruschenko Oleksandr >> > > > _______________________________________________ > Xenomai-help mailing list > [email protected] > https://mail.gna.org/listinfo/xenomai-help > >
_______________________________________________ Xenomai-help mailing list [email protected] https://mail.gna.org/listinfo/xenomai-help
