Something I noticed on the Windows (and Macintosh) install that may be relevant to 
your problem:

The binary distribution installs headers into /include, and purposefully does not 
contain any *Impl.  The source distribution installs headers and source into /src, and 
does contain the *Impl files.

This leads me to believe that you are building 2.3.0 looking in the /include directory 
for your headers, when you should be looking in /src.

adam

-----Original Message-----
From: Allen Williams [mailto:[EMAIL PROTECTED]
Sent: Sunday, September 21, 2003 5:28 PM
To: [EMAIL PROTECTED]
Subject: Install bug?

I think I found a bug in the xerces 2.3 install.  When it went to make the
parsers, none of the "Impl"- type include files were being found in
AbstractDOMParser.cpp.  Rather than figure out which make variable wasn't
being set correctly, I just copied all the Impl.hpp's into
/include/xercesc/dom/impl, or whatever that directory is, where I knew the
compiler would look.  So, I got it built, but the bug needs to be fixed.  Is
this the correct list to post bugs like this?  I'd be glad to report it in a
form on the web site if one exists.

Oops!  I just checked my compile window, and found another bug.  When make
says "Building /lib/libxerces-c.so.23.0", it then goes off and does a
make -C /obj/LINUX/.. -k.  There is no /obj/LINUX.  Evidently, even though I
set the environment variable, XERCESCROOT, and check to ensure it was set,
it was not getting picked up in the make file and being prepended to
/obj/LINUX (in my case, it should have been
/usr/local/src/xerces/xerces-c-src_2_3_0/obj/LINUX).

Again, I just hard- coded it in the make file so I could move ahead.

Also, the installation doesn't put the files in the right places.  I built
with:

./configure --prefix=/usr/local

And the files went into /lib and /include.

Thanks,
A.

---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]

Reply via email to