I have a laptop with an ATI 3d Rage P/M card built in. I've been running Linux/XFree on it for several years with no problems. This morning I upgraded to SuSE 9.0, which included a X11 server that reports itself as XFree86 4.3.0.1. When I run the server the display comes up, but everything is wrapped or shifted aprox. 50 rows vertically. That is: the 50 rows that should be at the top of the display are at the bottom. Most everything works, but the pointer is also offset by about the same number of rows (i.e. to select something I have to click 50 rows below it)
The LCD is capable of 1024x768, xwininfo reports the correct screen size. I've tried any number of modelines, including those that the server generates. Most importantly I've also tried modelines and complete config files from my previous setup (version 4.2.0 I believe). These modes and/or config files worked with that server. In all cases valid mode lines result in the "wrapped" display. Guessing that the number 4.3.0.1 indicates modifications by SuSE, I also downloaded the 4.3.0 version from the XFree86 ftp server. It produced the same behavior as the 4.3.0.1 version. I downloaded the 4.4.0 stuff from development, but am having some trouble getting it to compile. I'll try again tomorrow, but I was hoping that someone else might have already seen and solved this problem. thanks __________________________________ Do you Yahoo!? Free Pop-Up Blocker - Get it now http://companion.yahoo.com/ _______________________________________________ XFree86 mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xfree86
