Luc Verhaegen wrote: > On Tue, Jun 15, 2004 at 09:59:45AM -0300, Paulo Mauricio Paes Barretto wrote: > > Hi, > > > > I have Mandrake 9.2 installed. Since my onboard VIA video isn't recognized, > > it is using VESA driver. > > > > I would like to know how can I get vertical refresh frequencies higher than > > 60Hz. My XF86Config-4 and XFree86.0.log files are attached. > > > > I've tryied some modifications in XF86Config-4, like adding specific > > ModeLines and changing options in Display Subsection, without success. The > > one attached is the original from installation. > > > > I've found in the log file lines suggesting that higher frequencies are > > possible, like: > > (II) VESA(0): Supported VESA Video Modes: > > (II) VESA(0): [EMAIL PROTECTED] > > (II) VESA(0): [EMAIL PROTECTED] > > (II) VESA(0): [EMAIL PROTECTED] > > (II) VESA(0): [EMAIL PROTECTED] > > > > But I can't understand the lines: > > (II) VESA(0): Attempting to use 85Hz refresh for mode "800x600" (114) > > (II) VESA(0): Attempting to use 85Hz refresh for mode "640x480" (111) > > ...attempting... and why not succeeding? > > > > Thank you for any possible help. > > > > Paulo > > > What "via video" is this? The CLE266 and KM/N400 have usable support > since xfree86-4.4.0 and you can easily compile the driver for 4.3.x. > > Luc Verhaegen > _______________________________________________ > XFree86 mailing list > [EMAIL PROTECTED] > http://XFree86.Org/mailman/listinfo/xfree86
The VIA chipset is KM400. I have, in a previous installation of Mandrake, successfully upgraded XFree86 to version 4.4.0 following the instructions in Install.txt and using Xinstall.sh. After upgrading, I changed the driver to "via" in Device Section. XFree started and worked, but I also coudn't get higher vertical refresh frequencies. In fact, I could get 1024x768 @ 75Hz, but my screen is not so big, and I want to use 800x600. These lines are from the VESA log file: (II) VESA(0): monitor1: Using hsync range of 31.00-65.00 kHz (II) VESA(0): monitor1: Using vrefresh range of 50.00-120.00 Hz and these values are correct for my monitor. Using the Via driver, I remember the range was much narrower in the corresponding lines. It seemed to me that was preventing the use of 800x600 at higher frequencies. There were also 4 messages of unresolved symbols in the log file. Well, then I gave up struggling with Via driver. I reinstalled Mandrake and tried to get what I need from Vesa driver. Is it possible to get 800x600 @ 75 or 85Hz from Vesa driver? If not, will you help me putting Via driver to work after upgrading again to 4.4.0? I'm about to give up using Linux because of a flickering screen. Thank you Paulo _______________________________________________ XFree86 mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xfree86