Oops, slight typo in comment: - /* Set DBE mode for TV out */ + /* Set VBE mode for TV out */
Hey, it was late and you get the idea... ;) --Leif On Fri, 7 Dec 2001 [EMAIL PROTECTED] wrote: > > Ahh, wonderful - thanks ! > > Vladimir Dergachev > > On Fri, 7 Dec 2001, Leif Delgass wrote: > > > I've adapted the experimental tvout code for Radeon/r128 in gatos cvs to > > Mach64 and I'm atttaching the patch (can be applied to atimode.c in ati.2 > > or the mach64 DRI branch). It works for me, but it has the same problem > > of garbling the text console and mode switching with Ctl-Atl-+/- doesn't > > work correctly. However, I did have success with enabling tv-out even if > > it's not plugged in and detected by the BIOS at boot. This uses card BIOS > > functions specific to Rage LT Pro (which is what I have), Rage XL, and > > Rage Mobility (mach64 variety), but only if one of these chips is > > detected. Since the VBE functions are called for each mode switch, I can > > switch between my laptop LCD and TV by switching to a console, plugging in > > or unplugging the TV cable, and switching back to X. I changed the code > > from Radeon to recognize a display width of 800 (rather than 832), so I > > can use 640x480, 800x600 and 1024x768 without specifying custom modelines. > > However, it should also work with custom modelines as long as they use > > 640, 800, or 1024 width and 15, 16, or 32 bpp. > > > > This patch is of course rough and experimental, and I've only tested it on > > my setup, so the usual caveats apply -- your tv/monitor might blow up, > > etc. ;) Peter, since you worked on the r128 patch, can you take a look > > at this? > > > > -- > > Leif Delgass > > http://www.retinalburn.net > > > > > > > -- Leif Delgass http://www.retinalburn.net _______________________________________________ Xpert mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xpert