New question #699072 on Yade: https://answers.launchpad.net/yade/+question/699072
Dear all, As discussed in [1],I have installed the Source code and use the yade-2021-03-16.git-61c9069.I ran the script in example/thermalengine and found some new problems after my changes. The thermoHydroMechanical_coupling.py and flowScenario.py can run as expected.The problem is mainly in noFlowScenario.py. 1.When I run the original script (unchanged), the problem is the same as before: plot is blank and body.State.Temp = Nan. 2.My changes to the script are as follows: >>#sp = O.bodies.append(ymport.textExt('5cmEdge_1mm.spheres', >>'x_y_z_r',color=(0.1,0.1,0.9), material='spheres')) sp=pack.SpherePack() sp.makeCloud(mn,mx,rMean=0.0015,rRelFuzz=0.333,num=100,seed=1) sp.toSimulation(color=(0.752, 0.752, 0.752),material='spheres') (That is, change the way the sphere is generated,this is the only change) Then I ran the script again and was surprised to find that the simulation ran successfully as expected. However,I changed the num in makeCloud and found the bad thing:when the num=300,the problem mentioned above reappears:plot is blank and body.State.Temp = Nan... I also tried using randomDensePack,and the problem is the same. So I guess the problem has something to do with the number of spheres? Thanks for your help! Best regards. [1]https://answers.launchpad.net/yade/+question/698830 -- You received this question notification because your team yade-users is an answer contact for Yade. _______________________________________________ Mailing list: https://launchpad.net/~yade-users Post to : yade-users@lists.launchpad.net Unsubscribe : https://launchpad.net/~yade-users More help : https://help.launchpad.net/ListHelp