New question #707806 on Yade: https://answers.launchpad.net/yade/+question/707806
Dear All, I am currently facing a significant challenge while conducting UCS tests using the JCFmat model. The issue revolves around the parameter "intRadius," and I would appreciate your insights into its impact on the models. The problem arises when I set "intRadius" to 1.5. At this value, the UCS measures approximately 20 MPa. However, when I increase "intRadius" to 2.0, the UCS drastically jumps to around 200 MPa. In the second trial, the stress-strain curve deviates from the typical curve observed in our other tests. It initially exhibits an elastic stage up to 50 MPa, followed by a small peak, and then transitions into another elastic stage with a lower slope until it reaches the peak at 200 MPa. I suspect that the issue lies with the "intRadius" parameter. Does anyone have insights into what might be causing this? For reference, I am using the approach outlined in the paper available at https://hal.science/hal-01315522/. It would be immensely helpful if someone could provide a code snippet used in this paper for simulating the UCS test. Thank you for your assistance. Best regards, Mahdi -- You received this question notification because your team yade-users is an answer contact for Yade. _______________________________________________ Mailing list: https://launchpad.net/~yade-users Post to : yade-users@lists.launchpad.net Unsubscribe : https://launchpad.net/~yade-users More help : https://help.launchpad.net/ListHelp
