I'm into my nth install attempt via both manual and automatic. The scenario:
1 External HD running Panther,
2 Internal HDs, one of which is partitioned into Jaguar/Linux (about 1/4 size ratio). The second HD is for data storage.
After a few attempts, I had settled on the automatic approach using ext3 file system.
I had disconnected the external and the second internal HD to avoid risk of damage during Linux Installation.
By this time I had memorized the cryptic id of the correct target partition to install YDL.
So all went well and I was able to boot via either partition via the ALT key at reboot.
The problem:
When I reattached the external and 2nd internal drives and did a reboot, only the Mac OS Xes were available for booting via the ALT. The Linux was absent.
I've checked via the ExtFSManager System Pref. and can easily see the Linux sub-partitions there.
Question #1: Is there anyway to reset something to allow the Linux boot to be seen via ALT at startup, if necessary?
Question #2: Why did this occur?
So I had to re-install everything. This time I purposely left BOTH external HD and the 2nd HD in place so the LInux process can SEE these HDs if need to. <-- all HDs plugged in.
After re-installing YDL and rebooting in Linux, then Jaguar and Panther (external drive), I can still see ALL OS icons via ALT key at startup.
Hypothesis: If I change the configuration (remove a HD), perhaps Linux may be lost; and/or re-attaching HD(s) and rebooting...perhaps then I would loose Linux.
So back to Question #2: does changing the HD/Peripheral attachments prior to startup, have any effect on the Linux boot partition being seen?
I'm trying to get a STABLE system going here, before I invest time and sweat into loading tons of software.
Regards,
Ric. pseudo Linux-Psychologist Intern
_______________________________________________ yellowdog-newbie mailing list [email protected] http://lists.terrasoftsolutions.com/mailman/listinfo/yellowdog-newbie
