> I just installed YDL 4.0.1 on a Rev A iMac. The install went fine. > When I booted after install there was no network interface on the > ifconfig list, just the loopback interfaces. I used the Network > control panel dealie and there was a device listed in the Hardware tab > called "GMAC (Sun GEM)" with status "ok". There was no device in the > device tab. I added an Ethernet device to the appropriate hardware > device, saved and clicked activate and I got the dreaded: > > "sungem device eth0 does not seem to be present" > > I have searched the web and the mail lists and could find no advice on > how to proceed. According to the YDL site the network card in this > computer is supported. I have no idea how to make the eth0 device show > up in ifconfig. The Network system setting application seems to think > it is there and "ok". I have tried editing, adding, deleting hardware > and devices and restarting the network and rebooting and such to no > avail. > > What to do? > > Thanks! > Michael Koppelman
I'm having the EXACT same problem on my B-W G3? I thought it strange that I wasn't asked any network details while installing. Seems to be a bug in the installer, "ifconfig" only shows loopback device. Anyone got round this yet? Colin _______________________________________________ yellowdog-newbie mailing list [email protected] http://lists.terrasoftsolutions.com/mailman/listinfo/yellowdog-newbie
