On Mon, 2011-10-03 at 16:18 -0700, Tom Zanussi wrote: > On Mon, 2011-10-03 at 13:40 -0700, Darren Hart wrote: > > > > On 10/03/2011 12:07 PM, Tom Zanussi wrote: > > > On Mon, 2011-10-03 at 12:01 -0700, Richard Purdie wrote: > > >> On Mon, 2011-10-03 at 11:48 -0700, Darren Hart wrote: > > >>> When grub2 was merged int oe-core, it became the default (rather than > > >>> being explicitly requested by the 64b meta-intel BSPs). This breaks the > > >>> live install on 32b systems, like the n450 - installing grub v1.99 with > > >>> a grub v1 config. > > >>> > > >>> We have a couple options on how to fix this. > > >>> > > >>> 1) Set PREFERRED_PROVIDER_grub="0.97" in all 32b x86 machine configs > > >>> 2) Set DEFAULT_PREFERENCE="-1" in the grub_1.99.bb recipe which would > > >>> affect all of oe-core. > > >>> 3) Some alternate approach which would be the equivalent of > > >>> DEFAULT_PREFERENCE, but only for meta-yocto BSPs or the poky > > >>> "distro". > > >>> > > >>> Given the time frame, I'd prefer to agree on the approach before writing > > >>> and testing patches. Preferences? > > >> > > >> I thought I'd been assured grub2 worked fine for our 32 and 64 bit > > >> platforms? :/. > > >> > > >> The correct question here is why doesn't grub2 work on 32 bit platforms? > > >> > > > > > > I did test it with both 32-bit and 64-bit BSPs in meta-intel, so it > > > should work for the n450 too. > > > > I checked out edison in poky in meta-intel and built core-image-minimal > > for n450. By default it builds GRUB 2, which after install boots to a > > GRUB prompt with no menu. > > > > I'm not even getting that far with edison - it fails at 'Searching for a > hard drive'. I'd be happy to have it fail with no menu. > > Can you send me the commit ids for meta-intel and poky that actually got > you that far, and if you could a serial capture of the install? >
Never mind, I actually didn't have a hard drive (wrong power source). Once I changed that, I got a good install (on crownbay). It would still be useful to have the serial capture for the n450 though... Tom > Thanks, > > Tom > > > Using the PREFERRED_PROVIDER method above with the edison branches > > results in a GRUB 1 menu after install. > > > > -- > > Darren > > > > > > > > Tom > > > > > >> The answer might be "we need for time than is available in the 1.1 > > >> release to fix it" but I'd at least like to see the answer to the > > >> question before we start with workarounds. > > >> > > >> Cheers, > > >> > > >> Richard > > >> > > > > > > > > > > > _______________________________________________ > yocto mailing list > yocto@yoctoproject.org > https://lists.yoctoproject.org/listinfo/yocto _______________________________________________ yocto mailing list yocto@yoctoproject.org https://lists.yoctoproject.org/listinfo/yocto