From: Theodor Gherzan <theo...@resin.io> Signed-off-by: Theodor Gherzan <theo...@resin.io> --- README | 7 +++++++ 1 file changed, 7 insertions(+)
diff --git a/README b/README index 536926b..326b0bd 100644 --- a/README +++ b/README @@ -29,6 +29,7 @@ Contents: 3.L. Enable SPI bus 3.M. Enable I2C 3.N. Enable PiTFT support + 3.O. Enable UART support 4. Extra apps 4.A. omxplayer 5. Board Configuration @@ -233,6 +234,12 @@ the modelname should be added as a MACHINE_FEATURES in local.conf like below: List of currently supported models: - pitft22 +3.O. Enable UART +=============== +Set this variable to enable UART on raspberypi3: +ENABLE_UART = "1" + +Note: The value of enable_uart would be set to 1 by default on raspberrypi 1/2. 4. Extra apps ============= -- 2.1.4 On Thu, Apr 21, 2016 at 6:55 PM, Andrei Gherzan <and...@gherzan.ro> wrote: > On Thu, Apr 21, 2016 at 06:32:13PM +0100, Theodor Gherzan wrote: >> From: Theodor Gherzan <theo...@resin.io> >> >> Signed-off-by: Theodor Gherzan <theo...@resin.io> >> --- >> README | 4 ++++ >> 1 file changed, 4 insertions(+) >> >> diff --git a/README b/README >> index 536926b..cbc7a92 100644 >> --- a/README >> +++ b/README >> @@ -233,6 +233,10 @@ the modelname should be added as a MACHINE_FEATURES in >> local.conf like below: >> List of currently supported models: >> - pitft22 >> >> +3.O. Enable UART >> +=============== >> +Set this variable to enable UART: >> +ENABLE_UART = "1" > > Based on the explaination about enable_uart this is not quite right. > Cause on rpi1, rpi2 and cm it will get enabled without this variable by > default. So this needs a little additional information. > >> >> 4. Extra apps >> ============= >> -- >> 2.1.4 >> >> -- >> _______________________________________________ >> yocto mailing list >> yocto@yoctoproject.org >> https://lists.yoctoproject.org/listinfo/yocto > > -- > Andrei Gherzan -- _______________________________________________ yocto mailing list yocto@yoctoproject.org https://lists.yoctoproject.org/listinfo/yocto