Hi all,
I am running
zd1211rw 4-1:1.0: firmware version 4605
zd1211rw 4-1:1.0: zd1211 chip 6891:a727 v4330 high 00-14-7c RF2959_RF pa0 g---
IEEE 802.11b/g ESSID:"BLO" Nickname:"zd1211"
Mode:Managed Frequency:2.462 GHz Access Point: XX:XX:BB:LL:KK:00
Bit Rate:54 Mb/s
Link Quality=98/100 Signal level=91/100
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
in wpa/tkip mode.
I have a wired interface eth0 and the wireless one which was
detected as eth1 but named as eth3. How do I fix the name of the
wireless stick to eth1? I've played with udev:
KERNEL=="eth*", SYSFS{address}=="AA:BB:CC:DD:EE:FF", NAME="eth1"
or
KERNEL=="eth*", SYSFS{idVendor}=="6891", SYSFS{idProduct}=="a727", NAME="eth1"
but doesn't helped.
Could one advice me, please?
Elimar
--
Planung:
Ersatz des Zufalls durch den Irrtum.
-unknown-
-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys -- and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
_______________________________________________
Zd1211-devs mailing list - http://zd1211.ath.cx/
Unsubscribe: https://lists.sourceforge.net/lists/listinfo/zd1211-devs