Y post this:
[EMAIL PROTECTED] ~]$ su
Parola d'ordine:
[EMAIL PROTECTED] paolom65]# ifconfig
eth0 Link encap:Ethernet HWaddr 00:13:8F:79:40:4C
inet addr:192.168.2.2 Bcast:192.168.2.255 Mask:255.255.255.0
inet6 addr: fe80::213:8fff:fe79:404c/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4744 errors:0 dropped:0 overruns:0 frame:0
TX packets:3680 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:5544143 (5.2 MiB) TX bytes:291357 (284.5 KiB)
Interrupt:19 Base address:0xe000
eth1 Link encap:Ethernet HWaddr 00:14:C1:32:BC:75
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:2214 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:100709 (98.3 KiB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:360 errors:0 dropped:0 overruns:0 frame:0
TX packets:360 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:28512 (27.8 KiB) TX bytes:28512 (27.8 KiB)
[EMAIL PROTECTED] paolom65]# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
192.168.2.0 * 255.255.255.0 U 10 0 0 eth0
169.254.0.0 * 255.255.0.0 U 10 0 0 eth0
127.0.0.0 * 255.0.0.0 U 0 0 0 lo
default . 0.0.0.0 UG 10 0 0 eth0
[EMAIL PROTECTED] paolom65]# dmesg
i
ieee80211_crypt: registered algorithm 'NULL'
ieee80211: 802.11 data/management/control stack, git-1.1.13
ieee80211: Copyright (C) 2004-2005 Intel Corporation
<[EMAIL PROTECTED]>
usb 2-1.3: reset high speed USB device using ehci_hcd and address 4
zd1211rw 2-1.3:1.0: eth1
usbcore: registered new interface driver zd1211rw
Linux agpgart interface v0.102 (c) Dave Jones
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
Mobile IPv6
NET: Registered protocol family 17
zd1211rw 2-1.3:1.0: firmware version 4725
zd1211rw 2-1.3:1.0: zd1211b chip 0baf:0121 v4810 high 00-14-c1 AL2230_RF
pa0 g--NS
zd1211rw 2-1.3:1.0: error ioread32(CR_REG1): -110
ADDRCONF(NETDEV_UP): eth1: link is not ready
ieee80211_crypt: registered algorithm 'WEP'
eth0: no IPv6 routers present
fuse init (API version 7.8)
ip_tables: (C) 2000-2006 Netfilter Core Team
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (8192 buckets, 65536 max)
ip6_tables: (C) 2000-2006 Netfilter Core Team
nvidia: module license 'NVIDIA' taints kernel.
ACPI: PCI Interrupt Link [LNEC] enabled at IRQ 16
ACPI: PCI Interrupt 0000:00:05.0[A] -> Link [LNEC] -> GSI 16 (level,
low) -> IRQ 23
PCI: Setting latency timer of device 0000:00:05.0 to 64
NVRM: loading NVIDIA UNIX x86 Kernel Module 100.14.23 Thu Oct 4
10:16:34 PDT 2007
ctnetlink v0.93: registering with nfnetlink.
ClusterIP Version 0.8 loaded successfully
ndiswrapper version 1.49 loaded (smp=yes, preempt=no)
usbcore: registered new interface driver ndiswrapper
bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found
(1024x768, 22798 bytes, v3).
bootsplash: status on console 0 changed to on
bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found
(1024x768, 22798 bytes, v3).
bootsplash: status on console 1 changed to on
bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found
(1024x768, 22798 bytes, v3).
bootsplash: status on console 2 changed to on
bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found
(1024x768, 22798 bytes, v3).
bootsplash: status on console 3 changed to on
bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found
(1024x768, 22798 bytes, v3).
bootsplash: status on console 4 changed to on
bootsplash 3.1.6-2004/03/31: looking for picture...<6>...found
(1024x768, 22798 bytes, v3).
bootsplash: status on console 5 changed to on
eth0: no IPv6 routers present
eth0: no IPv6 routers present
ADDRCONF(NETDEV_UP): eth1: link is not ready
ADDRCONF(NETDEV_UP): eth1: link is not ready
Marking TSC unstable due to: cpufreq changes.
Time: acpi_pm clocksource has been installed.
Clocksource tsc unstable (delta = -102872507 ns)
eth0: no IPv6 routers present
[EMAIL PROTECTED] paolom65]# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
eth1 IEEE 802.11b/g ESSID:"USR9111" Nickname:"zd1211"
Mode:Managed Frequency:2.462 GHz Access Point: Invalid
Bit Rate=1 Mb/s
Encryption key:02A8-B3C4-8957-DE00-0000-0000-00 Security
mode:open
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[r
Y do not understand this error please explane me?
Regards,
Paolom65
-------------------------------------------------------------------------
SF.Net email is sponsored by: The Future of Linux Business White Paper
from Novell. From the desktop to the data center, Linux is going
mainstream. Let it simplify your IT future.
http://altfarm.mediaplex.com/ad/ck/8857-50307-18918-4
_______________________________________________
Zd1211-devs mailing list - http://zd1211.wiki.sourceforge.net/
Unsubscribe: https://lists.sourceforge.net/lists/listinfo/zd1211-devs