RAIDz set, lost a disk, replaced it... lost another disk during resilver.
Replaced it, ran another resilver, and now it shows all disks with too many
errors.
Safe to say this is getting rebuilt and restored, or is there hope to recover
some of the data? I assume this is the case because rpool/filemover has
errors, is that fixable?
# zpool status -v
pool: rpool
state: DEGRADED
status: One or more devices has experienced an error resulting in data
corruption. Applications may be affected.
action: Restore the file in question if possible. Otherwise restore the
entire pool from backup.
see: http://www.sun.com/msg/ZFS-8000-8A
scrub: resilver completed after 4h51m with 190449 errors on Sat Aug 25 05:45:12
2012
config:
NAME STATE READ WRITE CKSUM
rpool DEGRADED 455K 0 0
raidz1 DEGRADED 455K 0 0
c3t0d0 DEGRADED 0 0 0 too many errors
c2t1d0 DEGRADED 0 0 0 too many errors
replacing UNAVAIL 0 0 0 insufficient replicas
c2t0d0s0/o FAULTED 0 0 0 too many errors
c2t0d0 FAULTED 0 0 0 too many errors
c3t1d0 DEGRADED 0 0 0 too many errors
c4t0d0 DEGRADED 0 0 0 too many errors
c4t1d0 DEGRADED 0 0 0 too many errors
errors: Permanent errors have been detected in the following files:
rpool/filemover:<0x1>
# zfs list
NAME USED AVAIL REFER MOUNTPOINT
rpool 6.64T 0 29.9K /rpool
rpool/filemover 6.64T 323G 6.32T -
Thanks
Mark
_______________________________________________
zfs-discuss mailing list
zfs-discuss@opensolaris.org
http://mail.opensolaris.org/mailman/listinfo/zfs-discuss
