Hi Rolf,
I have now worked out what caused the scanner to work. When I reboot my
machine and run scanimage, it always it fails, I have pasted the very short
log I get on failure below.
However, if I launch virtual box and then connect it to the scanner so that
it grabs that USB device, then
Hi Giles,
Yes, the PPA is compiled with libusb. I just tested Ubuntu 18.04 with my
USB scanner.
I've seen in the log file that you might have connected your scanner
with WiFi. Please disconnect WiFi and test the scanner via USB only.
Please test with this command:
$ SANE_DEBUG_PIXMA=21
I installed sane from Rolf's PPA (not OOA!) So would assume that it is
compiled with libusb?
Thanks,
Giles
On Sun, 16 Sep 2018, 00:58 m. allan noah, wrote:
> Did you build sane-backends without libusb support too?
>
> allan
> On Sat, Sep 15, 2018 at 3:17 PM Giles Knap wrote:
> >
> > Hi Rolf,
Did you build sane-backends without libusb support too?
allan
On Sat, Sep 15, 2018 at 3:17 PM Giles Knap wrote:
>
> Hi Rolf,
>
> I now have tried your latest driver from your OOA on a clean install of
> Ubuntu.
>
> In this case I cannot see the scanner at all. Can you advise as to possible
>
Hi Rolf,
I now have tried your latest driver from your OOA on a clean install of
Ubuntu.
In this case I cannot see the scanner at all. Can you advise as to possible
reasons for this?
See log below.
Many thanks,
giles.
ubuntu@ubuntu:~$ SANE_DEBUG_PIXMA=21 simple-scan
OK, I repeated the test with wireless LAN disabled on the scanner (it has
no ethernet connection).
The results are the same (except this time I did not turn on BJNP debugging
- if I do then the output is identical to previously).
See below.
Thanks,
giles
Hi Giles,
As I mentioned before, very probably your scanner cannot be used via
Ethernet and WiFi. Please retry scanning via USB connection. Then you
should remove the Ethernet cable and/or disable WiFi.
Hope this helps.
Cheers,
Rolf
Am 12.09.2018 um 23:21 schrieb Giles Knap:
> Thanks Rolf,
>
Thanks Rolf,
I was immediately able to see the scanner but unfortunately when I try to
scan I get an error. I have tried power cycling the scanner and restarting
ubuntu but get the following:-
Thanks,
giles.
giles@gklinux:~$ SANE_DEBUG_PIXMA=21 SANE_DEBUG_BJNP=3
Many thanks, Rolf.
I would be very happy to have my scanner working via USB.
The USB IDs are as follows:-
Bus 002 Device 005: ID 04a9:1822 Canon, Inc.
Cheers,
giles
On Wed, Sep 12, 2018 at 6:41 PM Rolf Bensch wrote:
> Hi Giles,
>
> I'm sorry to tell you that your scanner isn't supported by
Hi Giles,
I'm sorry to tell you that your scanner isn't supported by SANE. You
confuse your TS6150 with the TS6050 (PIXMA TS6000 Series).
There's another problem with the tested TS scanners: WiFi isn't working.
I can quickly implement your scanner to SANE, but you very probably need
to use
10 matches
Mail list logo
