On 17/07/2007, at 9:03 PM, Samuel Gundry wrote:
Hi Chris and Markus,
Thanks for the responses. I cannot see the two entries of my own node or
the "APAG AudioReflector" node in Rat itself, when in the Audio Reflector venue.
I turned off the firewall (I know, silly) and installed the audio reflector
controller app and received the following error:
17/07/2007 20:53:51 : Started
17/07/2007 20:54:12 : Failed contacting server (socket.error:(10060,
'Operation timted out'))
I adjusted the reflection delay and pressed apply but it still timed out...
It certainly seems like a firewall error of sorts, any ideas? Might be my
router, do I need to open a specific port?
Sam,
There are 2 issues involved concerning the controller application. Firstly,
the existing controller app was written for AG2 and, secondly, the reflector
server location (which is hard coded into the app) is out of date.
I've created an updated controller shared application for AG3 and put it in
the Data section of the Audio Reflector venue of the vv3.ap-accessgrid.org
venue server. I've just tested it from home (no multicast) and it works fine
although there are no built-in sounds available on the server.
The bars in Rat are moving up and down as I speak into the microphone, but
there is no bars in the listen section. Does this mean that my microphone input
is local for Rat, but the server cannot be contacted to listen to the sound?
It looks that way. Have you tried connecting via a bridge? That may work
around a multicast problem at your end.
chris
Markus Buchhorn wrote:
You should also run the audio reflector controller application (which is
normally stored in the venue data - I can't check or test right now). That has
the option to play back standard sounds stored in the reflector, so you can
test inbound paths separately from outbound.
Cheers,
Markus
At 10:35 AM 17/07/2007, Christoph Willing wrote:
On 16/07/2007, at 8:26 PM, Samuel Gundry wrote:
Hi,
The audio reflector and the second participant of me don't appear
when I visit the "Audio Reflector" venue (for AG 3.0.2), as per the
instructions here:
<http://www.accessgrid.org/node/354>http://www.accessgrid.org/node/354
Does the room work for anyone else? Or is the room broken?
I used it successfully yesterday when testing a laptop node in the
Library and again just now from our lab node.
I'm using this address:
<https://vv3.ap-accessgrid.org:8000/Venues/00000103104e90bd0081004e009d00a8bbc>https://vv3.ap-accessgrid.org:8000/Venues/00000103104e90bd0081004e009d00a8bbc
I want to test out my sound (obviously), the bars in RAT are moving
but I don't have any way to test the sound...
Perhaps your signal isn't reaching the reflector. When you're in that
venue, you should see the "APAG AudioReflector" entry in rat itself. You should
also see 2 entries for your own node. If you don't see all those entries then
your traffic isn't being seen (and audio reflection can't work) - therefore
check your firewalls, multicast etc.
chris
Christoph Willing +61 7 3365 8350
QCIF Access Grid Manager
University of Queensland
Christoph Willing +61 7 3365 8350
QCIF Access Grid Manager
University of Queensland
