Matt
 
I know nothing of water coolers so I can't comment on that, and I don't know
about a pipe-style heatsink either. But I wonder about this: you have a
front-mounted fan blowing in. Now if a side fan was installed that
essentially blows in at 90deg to the front fan, I'm wondering whether some
of the side fan pressure, as its flow bends sideways when it hits the MB,
will splash forward and that backpressure may actually reduce the flow of
that front fan. Something to think about. Other components on the MB
probably don't need additional cooling since those components are spread
out, whereas the CPU has to dissipate 130 watts emanating from a very small
space, and maybe the graphics card which also generates heat. Some mfgr's
funnel onto or away from the CPU (I've seen Dell and HP funnel away). Or
perhaps that side fan could/should be another exhaust (just guessing, I
don't really know). What if you had two front fans? The top and rear exhaust
fans are probably perfect. Hopefully your CPU fan/heat-sink combo are sized
correctly. 
 
Just a few more thoughts, not to run this into the ground too much!
 
Lee
 
From: [email protected] [mailto:[email protected]]
On Behalf Of skulldrinker
Sent: Friday, October 08, 2010 6:14 PM
To: [email protected]
Subject: Re: [AP] Premiere and CPU Temp
 
  
Lee,

Yes, it is a Desktop with stock fan in front blowing in over the hard 
drives and on up top blowing out. About the 12" fan, I tried to lower 
the temp by removing the side cover and taking my table top fan and 
pointing it at the inside of the case blowing over the motherboard and 
CPU but that only kept it from peeking above 87 keeping it down around 
83. The case does have optional mesh cutouts for adding fans 2 more on 
the side cover that would blow right on the MB (just like mt 12"er and 
one more location on the rear. So I ask myself do I spend $30 on 3 more 
fans and connectors and $50 plus on a pipe style CPU heatsink or just 
spend $79 bucks on a cooler. I read over on the gamer sites some say 
the pipes didn't help all that much but every water cooler did the job.

If I was only going to do 1 or 2 minute clips for you tube I might not 
worry so much but running at 85C for 1 or more hours at a time I'm a 
little worried about that.

Matt

On 10/8/2010 3:23 PM, Lee Menningen wrote:
>
>
> I have an i7-940. 80 sounds pretty high to me. I use SpeedFan and whenever
> the temp hits 50c (they go to 52-56 during PPro rendering ), SpeedFan
> changes its icon to a flame, so the SpeedFan programmer must think even 50
> is pretty hot.
>
> Desktop? If so, be sure that not only is there air flowing through the 
> box,
> but that there is plenty of exhaust air, so that no hot air can build up
> anywhere inside the box. Why a 12" fan? Check some of the gamer web sites
> where this topic is discussed. They'll point out things, such as some air
> focused on certain points, and flowing front-to-back and not simply 
> swirling
> around inside the box. The CPU should/will have its own fan but sometimes
> its heat sink needs extra air. Some people put extra fans on the graphics
> intake even when it has an on-board fan. Anyway, you should find lots of
> tips.
>
> I ended up putting two 120mm fans on the front disk cage, a case 
> top-exhaust
> fan, and it already had a rear exhaust. I run them at a low speed so they
> are inaudible but they are very effective.
>
> Lee
>
>
>
> 

[Non-text portions of this message have been removed]



[Non-text portions of this message have been removed]



------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Adobe-Premiere/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/Adobe-Premiere/join
    (Yahoo! ID required)

<*> To change settings via email:
    [email protected] 
    [email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/

Reply via email to