It's important to note when you attach the duplexors to the radio that
you are tightening both SMA connectors at the same time.
They warn about damage than can occur if you tighten them down one at a
time.
On 7/3/2019 10:14 AM, Keefe John wrote:
They are N Connectors and they came with the adapter from Chuck.
We're going to double-check the tightness of the adapter and swap the
leads tonight.
On Wed, Jul 3, 2019 at 10:05 AM <ch...@wbmfg.com
<mailto:ch...@wbmfg.com>> wrote:
Could be the adapter. They are pretty simple and hard to screw
up, but the cables could be bad too. I have made very few of
these things. So far, no failures that I know about but there is
always the first time.
*From:* Ken Hohhof
*Sent:* Wednesday, July 3, 2019 9:00 AM
*To:* 'AnimalFarm Microwave Users Group'
*Subject:* Re: [AFMUG] 20 Db Loss with AF-11FX Adapters
Make sure you don’t have a mixup between SMA and RPSMA
connectors. I did that once, I assumed everything was RP and got
an antenna with regular SMA connectors on it. Had to buy
different coax cables. Signal was trying to jump the air gap
between two female inner connectors.
*From:* AF <af-boun...@af.afmug.com
<mailto:af-boun...@af.afmug.com>> *On Behalf Of *Keefe John
*Sent:* Wednesday, July 3, 2019 9:28 AM
*To:* AnimalFarm Microwave Users Group <af@af.afmug.com
<mailto:af@af.afmug.com>>
*Subject:* Re: [AFMUG] 20 Db Loss with AF-11FX Adapters
The TX power is correct.
We'll double check the tightness but the techs said they didn't
see an issue when installed.
It is possible the leads are switched at one end, however you are
correct Chuck that UBNT claims that doesn't matter with this radio.
Is anyone sure the Dragonwave dishes actually work with two
polarities at once? I believe the literature says single pol. I
know they are dual pol in that you can connect a Dragonwave either
horizontally or vertically on the back of the dish but can you use
two polarities at once?
Keefe
Keefe John
CEO
Ethoplex
Direct: 262.345.5200
--------------------
Ethoplex Business Internet
http://www.ethoplex.com/
Signal Residential Internet
http://www.signalisp.com/
https://www.linkedin.com/in/keefejohn/
On Wed, Jul 3, 2019 at 8:56 AM Chuck McCown <ch...@wbmfg.com> wrote:
Both chains and both directions? Cross pol would be about
20db down but doesn’t that radio automagically take care of
that for you?
Sent from my iPhone
> On Jul 3, 2019, at 7:24 AM, Keefe John <kj...@ethoplex.com>
wrote:
>
> We took a Dragonwave Horizon Compact Pluses off a link and
used Chuck's adapters to install AF-11FXs on the Dragonwave
dishes. Now we're seeing a 20 Db signal loss on the RSL. The
DSL with the original Dragonwaves was 1 or 2 db off the PCN.
What could be the problem?
>
> Keefe
> --
> AF mailing list
> AF@af.afmug.com
> http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
------------------------------------------------------------------------
--
AF mailing list
AF@af.afmug.com <mailto:AF@af.afmug.com>
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
AF@af.afmug.com <mailto:AF@af.afmug.com>
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com