Cambium has a kit that seemed at first a little intimidating at first
but now we use them all the time with no water intrusion.
Here is that part number
N000082L173
It looks like a little braided loop strap but it gets strapped to the
half inch exposed armor and sealed with butel and fat tape.
looks good when done right.
On 9/30/20 4:49 PM, Daniel White wrote:
To answer one part... yes you can put grounding kits mid-span on the
cable. Had to do that a few times. I think we used the standard
LMR-400 kits.
photograph
Daniel White
Co-Founder
phone: +1 (702) 470-2770
direct:+1 (702) 470-2766
Nate Burke <mailto:n...@blastcomm.com>
September 30, 2020 at 09:44
Does anyone sell custom length, per-terminated BBDGE cable? I have
an application where I need the copper cladding tied to the shielded
RJ45.
Also, has anyone used grounding kits on the cable for mid-span
grounding? Will Coax cable kits work on it?
It's been years since I've worked with that cable, I think back when
it had to be punched into the PTP400 LPU Units. I remember it being
a pain to field terminate.
One of our tower sites just put up antennas at 6.9, 9.2 and 14.7mhz
and it's causing all kinds of Ethernet problems for our cables that
pass through their array. They want to run at 5-6kw, and we start
having problems when they go over 2kw. They are hoping that if we
change to the BBDGE cable with lots of Grounding, it will fix the
problems. Already have Coils at the top and bottom on Beldon7919
cable. That got us from 400w failure to 2kw failure.
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
