Could it be an ethernet issue?
The only other time I have seen latency across a dragonwave link is when
it is saturated. Your limit is actually 364 mbps. Is it possible you
are peaking up to this for short periods of time? We have seen issues
where our graphing system (cacti) is showing 200 mbps usage(with 1
minute average) but real-time peaks were maxing out the capacity.
Keefe
On 10/22/2014 2:05 PM, Joshua Heide via Af wrote:
Yes it�s a horizon compact
Bandwidth of the unit is 400mbs
Bandwidth usage between 150-200mbs during peak hours.
No QOS
Yes during non-peak hours its sits at 1ms
SNR 35.00 dB
From our prtg graphs this issues has started end of September and
latency has gotten worse during peak times as we have deployed more
450 gear to that tower.
I currently have HAAM enabled on the link and it stays at 256qam
unless we have some bad weather.
Josh Heide
Velociter Wireless
(office) 209-838-1221
(fax) 209-838-1800
www.velociter.net <http://www.velociter.net/>
*From:*Af [mailto:[email protected]] *On Behalf Of *Bill Prince via Af
*Sent:* Wednesday, October 22, 2014 11:47 AM
*To:* [email protected]
*Subject:* Re: [AFMUG] Dragonwave latency issues
So it's a Horizon Compact?
What is the total bandwidth, and what percentage are you using? Have
you set up any QOS? 180 ms sounds like a lot; especially when ours
are typically less than 1 ms.
-38 is right in the game. What are the other parameters besides signal
level?
bp
On 10/22/2014 11:18 AM, Joshua Heide via Af wrote:
We have a dragonwave that has latency issues that coincide with
traffic peak times. As our traffic peaks so does that latency at
180ms. Any ideas that could cause this?
Signal is -38
Current HAAM Mode hc50_364_256qam
Thanks,
Josh Heide
Velociter Wireless
(office) 209-838-1221
(fax) 209-838-1800
www.velociter.net <http://www.velociter.net/>
