*doing it with a ben*ch grinder*.
I was at a machine shop where they were doing it with a ben
You can do it by hand with a bit of practice.
�
*From:* Glen Waldrop <mailto:gwl...@cngwireless.net>
*Sent:* Wednesday, June 03, 2015 4:24 PM
*To:* af@afmug.com <mailto:af@afmug.com>
*Subject:* Re: [AFMUG] Sharpening Drill Bits
�
My dad has always sharpened his own, so I tend to do the same.
In my experience, if used in wood they can be sharpened with little
issue. If you drill through metal, buy a new one.
�
It loses some of the hardness on the edge. It really needs to be
tempered again after sharpening.
�
�
----- Original Message -----
*From:* Rory Conaway <mailto:r...@triadwireless.net>
*To:* af@afmug.com <mailto:af@afmug.com>
*Sent:* Wednesday, June 03, 2015 5:18 PM
*Subject:* [AFMUG] Sharpening Drill Bits
�
We are paying $15-$25 for longer drill bits.� When they start
to get dull, just wondering if anyone has had success sharpening
them or do you just buy new ones?
�
*Rory Conaway **� Triad Wireless �**CEO*
*4226 S. 37^th Street � Phoenix � AZ 85040*
*602-426-0542*
*r...@triadwireless.net <mailto:r...@triadwireless.net>*
*www.triadwireless.net <http://www.triadwireless.net>*
**�
*�You may be an engineer if your idea of good interpersonal
communication means getting the decimal point in the right
place.� � Unknown*
�