Hey, if they need failed hardware to figure it out, fine with me.
On 8/7/2015 6:45 AM, Mike Hammett wrote:
In my experience, if you complain a lot and offer to drive it to them,
they take you up on it. ;-)
-----
Mike Hammett
Intelligent Computing Solutions
http://www.ics-il.com
------------------------------------------------------------------------
*From: *"George Skorup" <geo...@cbcast.com>
*To: *af@afmug.com
*Sent: *Friday, August 7, 2015 1:03:18 AM
*Subject: *Re: [AFMUG] RF Calibration Failure ADI Catalina R1 chip not
supported!
I have two on my desk that I submitted support case requests for and
haven't got a response yet. You want me to drive them up to Rolling
Meadows? :)
The 5GHz SM shows RF calibration failure and ADI communication
failure. The 3GHz SM shows only RF calibration failure. They both
reboot shortly after starting to scan. I think I might have another
5GHz in my WTF pile too, have to check tomorrow.
On 8/6/2015 11:37 PM, Rajesh Vijayakumar wrote:
We are waiting for the RMA'd units to reach us, so we can look at
what is going on. I am told we should get at least one unit on
Monday. I will provide more details as soon as possible. I am
sorry about the trouble this is causing.
Rajesh Vijayakumar
Cambium Networks
On Thu, Aug 6, 2015 at 1:14 PM, Brian Sullivan
<installe...@foxvalley.net <mailto:installe...@foxvalley.net>> wrote:
We have had a few.
On 8/6/2015 12:12 PM, timothy steele wrote:
yeah same here 1 was a tower climb.. was hoping someone
knew whats making this happen as they work fine out of the
box then die later
On Thu, Aug 6, 2015 at 12:16 PM, George Skorup
<geo...@cbcast.com> wrote:
Had a couple 3GHz and 5GHz SMs last week as well.
Replace and RMA is the only solution.
On 8/6/2015 11:11 AM, timothy steele wrote:
we have had 2 brand new 5ghz 450's out of the blue
have the RF die and show in re letters
RF Calibration Failure
ADI Catalina R1 chip not supported!
They both where running 13.2.1 and both where
installed for a week or so before they stopped
running tired defaulting both and upgrading
firmware on both did not work they also randomly
reboot the 2 where installed a 2hr drive apart
connected to diffrent towers
anyone have any clue whats going on here??
Thanks
