What does FreeRun have to do with it?
I have a couple 450 test sites on 13.4 and haven't seen any watchdog
resets. Granted, that's only two APs. Definitely still see it on 13.2.1.
It's not a daily thing, but yeah, annoying.
One thing I'm seeing on the 3.6 450 with 13.2.1 is the APs getting into
a state where they say there's no sync pulse. Then it says receiving
sync, no sync... over and over every few seconds until they are
rebooted. All the while the SyncInjector says nothing is wrong. Tracking
8+ sats. No increment for the 1PPS Active counter. I understand this had
something to do with the FreeRun stuck issue, which was apparently
resolved with 13.4, but I'm waiting on 13.4.1 so some other issues get
fixed before I can update the entire network.
Anyway, if I leave the APs alone for a while (say it happens in the
middle of the night while I'm sleeping), they mysteriously return to
normal after anywhere from 3 to 20 minutes. Then if any SM loses
registration (or if I force an SM to rescan), it fails to register for
no reason at all. Reboot the AP, everything works again. I have no
freakin idea what this is about.
On 8/28/2015 9:54 PM, Mark Radabaugh wrote:
We have been seeing this across 200+ AP's
It's getting truly annoying. Cambium tech support has helpful suggestions
like'just put them in free run'. Um.... Thanks for the help, but no.
Mark Radabaugh
Amplex
27800 Lemoyne, Ste F
Millbury, OH 43447
419-261-5996
On Aug 28, 2015, at 4:56 PM, Brian Sullivan <installe...@foxvalley.net> wrote:
Last week we rolled out 13.4 to 450 AP's after testing in-house for a while.
While running 13.2 we would see an AP here or there reboot on occasion by
itself. The only message in the Event Log mentions Watchdog Reset. This is
one of the bugs that Cambium noted was fixed in the 13.4 release notes.
Since we upgraded the network to 13.4 we are now seeing at least 4 AP's out
there rebooting several times per day. On one of these AP's we are also seeing
SM's (all 17 registered) reboot along with the AP. The site has UPS backup so
I know it's not a power grid problem. I am planning to roll the affected AP's
back to 13.2 this evening.
Anyone else having Watchdog issues with the 13.4 release?
******System Startup******
System Reset Exception -- Watchdog Reset
Software Version : CANOPY 13.4 AP-DES
Board Type : P12
Device Setting : 5.7GHz MIMO OFDM - Access Point - 0a-00-3e-a0-08-e5 - 5760.0
MHz - 20.0 MHz - 1/16 - CC 85 - 2.5 ms
FPGA Version : 040715
FPGA Features : DES, Sched, US/ETSI;
08/28/2015 : 14:11:42 CST : :Time Set
08/28/2015 : 14:11:58 CST : Acquired sync pulse from Power Port.