Spring nuts? On Fri, Sep 25, 2015 at 9:05 AM, Adam Moffett <dmmoff...@gmail.com> wrote:
> Washers could stop the horizontal strut from hitting the side of the tank, > but the two vertical struts will be rotated away from each other. > > Are there fittings to connect them at an angle to each other rather than > perpendicular? > > > On 9/24/2015 9:39 PM, Mark Radabaugh wrote: > >> Huh - that’s awesome. >> >> I have a tank like that I have been trying to figure out a better mount >> for. Never thought of using unistrut vertical on the rails. >> >> Look in the unistrut catalog and you should find enough parts to build >> something close. >> >> I’m thinking two struts vertical with beam clamps to clamp them to the >> horizontal banding, and then horizontal strut across with spacers (square >> washers) to compensate for the radius. Pipe clamps to hold the round pipe >> vertical. >> >> Mark >> >> On Sep 24, 2015, at 9:22 PM, Adam Moffett <dmmoff...@gmail.com> wrote: >>> >>> I need to attach to a water tank identical to the one in the Sprint >>> installation in the attachments. >>> >>> I noticed the drawing doesn't match the as-built photo. In the drawing >>> they're calling for galvanized angle bent around the curvature of the >>> tank. In the photo it's flat plates. Gee, I wonder which one bent easier. >>> >>> Does anyone sell ready made hardware for this, or is it going to be >>> custom fab stuff? >>> >>> <antenna 5.pdf><Attenna mounting detail Glass Lined Tanks.pdf> >>> >> >