Side note, have you looked at the manual? It's quite good. I did all my config via CLI, so there's something I might have done in there at the time that may not be available in the GUI - I don't know. On Apr 12, 2016 8:56 AM, "Josh Reynolds" <[email protected]> wrote:
> Something is off in your config somewhere. > > I've got some meetings this morning, but I should be back to the NOC > before noon. I've got 6 edgeswitches of various shapes and sizes in one of > our racks, so I'll try it when I get back in to see if I can help you > figure out your issue. > On Apr 12, 2016 8:49 AM, "Justin Marshall" <[email protected]> wrote: > >> Tried that too… Still can’t ping it >> >> >> >> *From:* Af [mailto:[email protected]] *On Behalf Of *Josh Reynolds >> *Sent:* Tuesday, April 12, 2016 9:46 AM >> *To:* [email protected] >> *Subject:* Re: [AFMUG] EdgePoint S16 >> >> >> >> Make sure it's got an untagged vlan assigned to it >> >> On Apr 12, 2016 8:43 AM, "Justin Marshall" <[email protected]> wrote: >> >> Hi, >> >> >> >> >> >> I have an Edgepoint S16, and have an IP address assigned directly on one >> of the interfaces done through Routing->IP->Interface Configuration. >> However, I am unable to reach that IP when directly connected to that >> interface through a laptop. >> >> >> >> >> >> I can still reach the IP Address assigned under >> System->Connectivity->IPv4. >> >> >> >> >> >> I need to be able to reach the interfaces directly through IP addresses >> assigned only to those interfaces. What am I missing here? >> >> >> >> Tried excluding the port from the default VLAN just to see if that would >> make a difference, but ultimately will not be able to do that once it’s >> deployed anyways… >> >> >> >> Thanks >> >
