Assuming the scanning caused it, then it wouldn't be a re-reg since that
doesn't trigger a full scan. You could look at the session log for that
SM and see if that shows any out-of-service (OOS) and/or reg attempts.
Maybe Aaron can tell you exactly what that means. Bad frequency offset
at that temperature or something. Lets see if a "paging Aaron Schneider"
triggers his filter........
On 4/13/2016 2:08 PM, Ken Hohhof wrote:
Yes, I normally turn off 5 MHz and the 2.5 MHz raster (otherwise it
would take forever to register), but I leave both 5.4 and 5.7
frequencies checked just in case.
Your scenario assumes it had to rereg, correct? Not sure what caused
that.
-----Original Message----- From: George Skorup
Sent: Wednesday, April 13, 2016 2:02 PM
To: [email protected]
Subject: Re: [AFMUG] 450 "silent watchdog reset" question
Could be it pooped while scanning that frequency. Do you have the 5.4
band scanning enabled on that SM?
On 4/13/2016 1:53 PM, Ken Hohhof wrote:
04/13/2016 : 11:09:46 UTC : :Reset due to error setting transmit
frequency 5540 at temperature 24 C
04/13/2016 : 11:10:46 UTC : :Forced reset;
04/13/2016 : 11:10:46 UTC :
******System Startup******
System Reset Exception -- Watchdog Reset Cur ExtInt 0 Max ExtInt 0
Cur DecInt 0 Max DecInt 0 Cur Sync 0 Max Sync 0 Cur LED 2 Max LED 1
Cur WDOG 0 Max WDOG 1 Cur EthXcvr 0 Max EthXcvr 1 Cur FEC 0 Max FEC 0
Cur FPGA 0 Max FPGA 2572 Cur FrmLoc 0 Max FrmLoc 0 Cur WatchDog 33
Max WatchDog 33 RTMLogStats 0 AAState 0
Software Version : CANOPY 13.2 SM-DES
Board Type : P11
Device Setting : 5.4/5.7GHz MIMO OFDM - Subscriber Module -
0a-00-3e-b2-04-4e
FPGA Version : 081514
FPGA Features : DES, Sched;
Note that the AP is on 5835 MHz, so I don't know why it says 5540.
-----Original Message----- From: George Skorup
Sent: Wednesday, April 13, 2016 1:08 PM
To: [email protected]
Subject: Re: [AFMUG] 450 "silent watchdog reset" question
It's not the same problem. The 450 AP and SM are different FPGAs. I do
see stack dumps and watchdog resets on SMs sometimes. I suspect that's
radios on crappy power/no UPS. Although, I have seen stuck VCs followed
by a dump and reset a few times.
Also, Aaron did say that the 450 hardware doesn't have a reboot
mechanism. So when you "reboot" a radio, they kill off stuff and let the
watchdog timer expire which then resets the board. So that's why you see
watchdog reset - user initiated reset, reboot from webpage or whatever.
On 4/13/2016 12:01 PM, Ken Hohhof wrote:
Is this just on APs, or also on SMs?
