I use these https://www.zoro.com/klein-tools-radial-cable-stripper-4-12-in-vdv120-006-sen/i/G0787753/?gclid=CI622Zni_80CFZSMaQod-7sEGA&gclsrc=aw.ds
They can still damage the shield. How deep it cuts depends on the amount of pressure that you put on your thumb. The stripper part inside cuts the wire every time, and is made for a much thinner cable. It is worthless when used like a typical stripper. I use the blade on top to strip (the one that is meant for cutting cable lengthwise), by holding pressure on the cable with my thumb and turning it. I like this stripper even better once it dulls out a bit. I haven't found anyone else that likes this stripper so YMMV. On Tue, Jul 19, 2016 at 7:47 AM, Ken Hohhof <[email protected]> wrote: > Ripley Smart Strip P/N 39470 around $10. Tessco carries them. > > *From:* Kade Sullivan <[email protected]> > *Sent:* Tuesday, July 19, 2016 7:49 AM > *To:* [email protected] > *Subject:* Re: [AFMUG] Cat5e/Cat6 Stripper That Doesn't Damage Shield? > > You pretty much need an adjustable cat 5 stripper to do shielded perfectly > every time. There are such wide ranges of outside insulation that it's > tough to find a preconfigured stripper that gets it cut perfect while > leaving thie shield in tact. > > I would buy one of the adjustable ones and adjust it for the shielded > cable you use. That will work out a lot better than the cheapo plastic > ones with no adjustments. > > On Tue, Jul 19, 2016 at 7:37 AM, Christopher Gray < > [email protected]> wrote: > >> I'm ready to get a better cable stripper. All 3 of my units easily damage >> the foil shield. >> >> Any recommendations for a good, consistent stripper for shielded Cat5e / >> Cat6? >> >> > >
