Yeah, I recently switched to the DC-1042 also.  With the foil not bonded to the 
inside of the jacket, I can finally fold it back over the jacket and not rely 
solely on the drain wire.

I highly recommend those little blue Ripley strippers, they are cheap enough 
you can buy one for each type of cable you use, adjust them, and mark them with 
a sharpie.  You can adjust it to cut like 90% of the way through the jacket so 
it never cuts the foil.

Had to get used to the left hand twist on the DC-1042.


From: George Skorup 
Sent: Tuesday, July 19, 2016 11:00 AM
To: [email protected] 
Subject: Re: [AFMUG] Cat5e/Cat6 Stripper That Doesn't Damage Shield?

What cable are you using? Does it have a rip cord? That's the easiest way to 
not score the shield.

What I do if a cable doesn't have the rip is strip it normally, let the foil 
tear off, then take a small pair of snips and cut the jacket down the length 
about an inch, fold it back and cut it off. Then fold the undamaged foil back 
and begin normal termination.

The Belden 7919A and Best-Tronics equivalent is a PITA like this. No rip cord. 
And the shield is teflon coated straight aluminum, not aluminized mylar, and it 
tears very easily. So I use my alternate method. It's very good cable, but way 
too expensive. We're using Shireen DC-1042 dry gel tape for tower cable now. No 
issues with it yet.


On 7/19/2016 7:37 AM, Christopher Gray wrote:

  I'm ready to get a better cable stripper. All 3 of my units easily damage the 
foil shield.  

  Any recommendations for a good, consistent stripper for shielded Cat5e / 
Cat6? 



Reply via email to