I was really hoping to buy some time on these customers with high re-registrations. It looks like I just need to find a new band. I can't cut down my frequency list since it is a remote site and I sometimes need to swap channels just to get a radio to register at all.
Time try some 2.4 at this spot. On Thu, Aug 11, 2016 at 10:42 AM, Adam Moffett <dmmoff...@gmail.com> wrote: > Like primary channel and backup channels? > > Seems like they could store in RAM what the most recently connected > channel was, and scan that channel a few times before going through the > whole scan list. Seems like it would reduce the service impact of a > re-reg. Just sayin.... > Is Aaron Schneider listening today? > > > > ------ Original Message ------ > From: "Matt" <matt.mailingli...@gmail.com> > To: "af@afmug.com" <af@afmug.com> > Sent: 8/10/2016 6:06:34 PM > Subject: Re: [AFMUG] Increase PMP100 900 MHz Stability in High Noise? > > If you go into the affected SM and disable all channels except for the one >>> the AP is on then it will register faster. This doesn't stop the >>> re-reging >>> but makes it less noticeable. >>> >>> I'm generally against that because then you can't change channels, but >>> sometimes you do what you have to do. >>> >> >> I really wish Canopy had a feature to only scan certain channels for X >> minutes, if unable to register in that time frame switch to another >> bigger channel group to scan. That way if you are forced too switch >> to a different channel and width due to interference etc. you can at >> least get your SM's back on the AP. >> > >
